How the best bathroom vanities list is built
This list goes by width because width is the one number you can't argue with. Your wall has a size. The vanity either fits it or it goes back in the box.
So the rule is simple. A vanity makes the list only if its maker states the width and whether a top is included. Then we spread the picks across sizes: no more than three at one width, no more than two from one brand, narrowest first. Popularity doesn't sort it, and neither does any brand.
The notes on each pick, above, stick to what the listing states. Where a listing leaves something out, like depth or cabinet material, the note says so. That's not a knock on the vanity. It's a reminder to ask before you order.
I install cabinets for a living, but not these. Nobody on this site has installed the vanities listed here. What we can do is read the specs closely and tell you which question to ask next.
The list, width by width
18 inches: the powder room
The narrowest pick is the eclife 18-inch freestanding vanity with an undermount sink. Its listing states a top with a single sink, MDF or engineered wood for the cabinet, and assembly required. An 18-inch vanity is for a half bath, a tight corner or a wall where the door swings close.
A small vanity is still a vanity. It still needs a drain and supply lines in the right place, and it still has to clear the door.
In a half bath, the 18-inch width is often what's left after the door and the toilet take their share. Stand where the sink will go, swing the door all the way open, and check that it doesn't hit the counter's corner. If it does, a narrower cabinet or a door stop fixes it before anything gets drilled.
24 inches: three with the top in the box
Three picks sit at 24 inches, and all three come with a top and a sink. The Jeffrey Alexander Cade and Chatham share the same layout in different finishes, black and Chocolate, and their titles name a white Carrara marble top with an undermount bowl. Both list soft-close.
The eclife 24-inch takes the other road: a ceramic vessel sink that sits on top of the counter, on a black freestanding cabinet. Its listing states MDF / engineered wood, soft-close and assembly required, and the title names a faucet and a pop-up drain. A vessel bowl puts the rim higher than the counter, so check the finished height against the people who'll use it.
The Cade and Chatham listings don't state depth or height. Get those numbers before you order. A 24-inch vanity is often going into a small room where every inch of depth decides whether the door clears.
29 and 35 inches: the in-between widths
The James Martin Vanities Brittany shows up twice, at 29 and 35 inches, both cabinet only and both in Saddle Brown. Odd widths aren't a mistake. Some walls are odd. Our 1962 house has a bathroom wall between the door trim and the tub that no standard width fits. It has character, Maya says, which is what you call a wall when you've stopped measuring it.
A 35-inch cabinet in a 36-inch opening leaves half an inch at each side, or a full inch on one. That's room for a filler strip, or for a wall that isn't square. Most aren't.
30 inches: the busiest width
Three picks share 30 inches, and they're three different answers to the top question:
- ARIEL Hepburn: base cabinet only, solid wood, 2 soft-closing doors and 1 dovetail drawer, per the listing
- Signature Hardware Fircrest: freestanding, with a rectangular integrated vitreous china sink
- Signature Hardware Rheya: a solid surface top with an integrated sink, in Winterland Walnut
Integrated means the sink and the counter are one piece. No seam to clean, no separate sink to mount. A base cabinet only means you buy the top separately, which takes longer but lets you match the counter to the rest of the room.
36 inches: three ways to fill a full yard
At 36 inches, the picks split three ways. The ARIEL Hepburn base comes in White Oak with 5 dovetail drawers and 2 soft-closing doors. The Wyndham Collection Sheffield is a freestanding single vanity in solid wood, sold without a top or sink. The Kohler Enivo is the wall-hung one, with a quartz top and an undermount sink.
Wall-hung vanities leave the floor open, which makes a small bath look bigger and makes mopping easy. They also hang their whole weight, top and sink included, on the wall. That's a job for blocking or studs behind the drywall, placed where the maker's instructions say. If you can't open that wall, pick a freestanding vanity.
48 inches: one sink, a lot of counter
The widest pick is the Wyndham Collection Daria at 48 inches. Its listing states a single undermount square sink, a Giotto quartz top drilled for a 1-hole faucet, and Dark Espresso with matte black trim. Forty-eight inches is where people start asking about two sinks. The NKBA recommends at least 36 inches between the centerlines of two sinks, so two sinks in 48 inches is tight. One sink and room to set things down is the more common answer at this width.
How to choose a bathroom vanity
Measure the wall, then the plumbing
Start with the wall. Then find where the drain and supply lines come out, called the rough-in. The vanity's back panel has to clear them, and the sink has to land over the drain. The maker's install sheet shows where the cabinet expects the pipes.
The National Kitchen & Bath Association's planning guideline gives the spacing numbers that matter here. It recommends at least 20 inches from the center of a sink to a side wall or tall obstacle, and cites 15 inches as the code minimum. For the toilet, it recommends 18 inches from the toilet's centerline to the nearest fixture or wall, with 15 inches as the code minimum. A wide vanity that crowds the toilet isn't a good vanity in that room.
Here's my one firm opinion for this page: a vanity's listed width is the box, not the room. Check the door swing, the toilet clearance and the floor space in front before you fall for a 48-inch cabinet in a room that wants 36.
Decide on the top before the cabinet
Every pick here says whether the top is included. That's the first fork in the road:
- Top included: one order, matched sink, fewer decisions
- Base cabinet only: you choose the counter, sink and faucet holes
- Integrated sink: counter and bowl in one piece, nothing to seal between them
If you go base only, the finished height grows by the thickness of the top. A vessel sink adds more. Our bathroom vanity height guide walks through that math.
Count the drawers you'll actually use
A vanity's storage is doors, drawers or both. Drawers keep small things findable. Doors hide the plumbing and the big bottles. The Hepburn 36-inch lists 5 drawers; the 30-inch lists 1. That's a big difference for the same family of cabinet.
Maya's call for our hall bath: one drawer per person who uses the sink, plus one for the hair dryer. Beau asked for a drawer for his rocks. The motion is still under review.
Read the material line
Some listings state solid wood or a solid wood frame. Others state MDF or engineered wood. MDF is a dense board made from wood fibers, and it's common in painted cabinets. Neither is automatically right. What matters is that the listing tells you, so you can decide how close to the shower and the tub that cabinet should sit.
Check the clearance in front
The NKBA recommends 30 inches of clear floor in front of a sink, and cites 21 inches as the code minimum. Deep vanities eat that space first. If the listing doesn't give depth, don't guess. Ask, or look for the maker's spec sheet.
Simple bathroom vanity or something more?
A simple bathroom vanity, a plain cabinet with a top and one sink, covers most bathrooms. Nothing on this list is fancy for the sake of it. The differences are practical: wall-hung or freestanding, top included or not, drawers or doors.
Cool vanities for bathrooms are mostly cool finishes. The finishes on this list come straight from the listings: Light Walnut, Black, Chocolate, Saddle Brown, Charcoal, Winterland Walnut, White Oak, Gray, Dark Espresso. Finish names belong to the maker. Two makers' "white oak" rarely match. If the vanity has to sit next to existing trim or a medicine cabinet, ask for a sample door or a finish chip first.
Who should skip this list
If you're replacing a vanity top and keeping the cabinet, you don't need a new vanity. You need a top that fits the cabinet you have, and you can start at vanity tops. If your bathroom has a pedestal sink and you like it, there's no rule that says you must trade it for a cabinet.
And if you have not measured the drain yet, skip this list for one more day. Measure it first. It takes five minutes and a flashlight. The vanity will still be here.
How we picked
The list draws from every bathroom vanity in our data whose maker states the width and whether a top is included. We kept at most three vanities per width and two per brand, then sorted narrowest first. The specs in the notes come from the Amazon US listings as of 2026-10-31, and we check availability weekly. A vanity that drops off Amazon US leaves the list automatically. Prices change too often to print, so we don't.
For the whole range, sorted by width, see bathroom vanities. For sizes in more detail, see bathroom vanity sizes.
Square and level.